欢迎来到Shenzhen Riqiya Electromechanical Co., Ltd.官网!
Shenzhen Riqiya Electromechanical Co., Ltd. is a foreign-funded enterprise established in 1992. It is mainly engaged in R&D and manufacturing of cold stamping, manufacturing and assembly, copiers, fax machines, typewriters, cameras, micro-motor automation office equipment parts, and auto parts. The next thing I want to share with you is the Shenzhen Machining craft tips, friends who are interested, can take a look!
There are a lot of small tricks in the machining process. There are many in the machining of lathes. In the machinery industry, even the rolling belt has been crawling for decades. There are certain researches on the process, although some things are very small, Very inconspicuous, but if we can learn from it, we can draw inferences from one another, and use our brains and find ways to help us in our work.
Tip 1: Remove the jaws of the vise, and process two M4 threaded holes, and rivet two 1.5mm thick steel plates that are flush with the jaws and rivet them with aluminum countersunk rivets A hard brass plate 3 with a thickness of 0.8mm is fastened to the jaws with M4 countersunk screws 1 to form a durable soft jaw. This can also protect the parts from being clamped and have interchangeability.
Tip two: It is not convenient to use a magnet to suck small parts (fee parts). You can suck an iron plate 2 under the magnet 1. Not only can you suck a lot of small parts, but also the iron plate Pull it apart, and the small pieces will be automatically poured into the collection box immediately, which is not enough to move your heart, but it is very practical.
Trick 3: When the pulley is driving, the pulley often slips between the pulley and the axle. Use ￠15~18mm dimple drill bit to make a series of dimples on the axle, which can form adsorption force and prevent slipping. The boss will reward you for turning waste into treasure.
Tip four: When the Allen wrench has a short handle and cannot be used to exert force, you can insert the wrench into the slot from a section of the slot with a slightly larger inner diameter than the wrench, which can be used as a long handle.
Tip five: Is there something to say about tightening the workpiece: first positioning and then clamping, but what? I think that for a workpiece, first clamp and then position, because the workpiece will definitely be deformed during clamping, so you should first clamp and then position. For 6-point positioning, try to limit its degree of freedom.
I hope that the above introduction of Shenzhen mechanical processing technology tips can be helpful to you, and we look forward to cooperating with you!
